comp.lang.idl-pvwave archive: archive

Home » Public Forums » archive » Re: Path Preferences

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Path Preferences [message #84579]

Tue, 04 June 2013 07:12

David Fanning
Messages: 11724
Registered: August 2001

Senior Member

Meg writes:

> I have some folders that I would like to add to my IDL paths. Unfortunately, every time I close IDL, the paths I added using the preferences section of the IDL workbench revert to their original state. I can tell that permanent paths have already been added by different people. Does anyone have any advice on making the paths stick?

Have you tried that black Velcro tape?

I've never heard of paths not "sticking". But, perhaps your Workbench
location is in a directory that you can't write to. I'd try changing
your Workbench location to a directory of your own that you control. If
it doesn't work there, then we may have to go back to the Velcro
solution.

Cheers,

David

--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.idlcoyote.com/
Sepore ma de ni thue. ("Perhaps thou speakest truth.")

Report message to a moderator

[Message index]

Re: Path Preferences

By: David Fanning on Tue, 04 June 2013 07:12

Previous Topic:	Path Preferences
Next Topic:	libGL error: failed to load driver: nouveau

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Tue Dec 02 13:24:42 PST 2025

Total time taken to generate the page: 0.46943 seconds