comp.lang.idl-pvwave archive: archive » Maximum likelihood fitting of an exponential fitting function in IDL

Home » Public Forums » archive » Maximum likelihood fitting of an exponential fitting function in IDL

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Maximum likelihood fitting of an exponential fitting function in IDL [message #91591]

Tue, 04 August 2015 09:01

atmospheric physics is currently offline

atmospheric physics
Messages: 121
Registered: June 2010

Senior Member

Dear All,

I have an exponential decay function as defined below:

FUNCTION tfunct,X,E
T = EXP(-((1000.0d*X)^E[1])/E[0])
RETURN,T
END

I was using MPFITFUN to get the fitting coefficients. Though this is working fine, I find that the fitting line is deviating away from the more likelihood points in the case when there were some outliers. Can I know if there is a maximum likelihood fitting function in IDL so that I can get the fitting line close to more number of points?

Look forward to your suggestions,

Thanking you,
With regards,
Madhavan

Report message to a moderator

[Message index]

		Maximum likelihood fitting of an exponential fitting function in IDL By: atmospheric physics on Tue, 04 August 2015 09:01
		Re: Maximum likelihood fitting of an exponential fitting function in IDL By: Bill Nel on Tue, 04 August 2015 10:27
		Re: Maximum likelihood fitting of an exponential fitting function in IDL By: Jeremy Bailin on Wed, 12 August 2015 10:35

Previous Topic:	calling C++ code from IDL
Next Topic:	EOF analysis

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Nov 28 08:22:57 PST 2025

Total time taken to generate the page: 0.00881 seconds