comp.lang.idl-pvwave archive: archive » map

Home » Public Forums » archive » map_set question

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

map_set question [message #6517]

Tue, 09 July 1996 00:00

gfu
Messages: 10
Registered: October 1995

Junior Member

Hi,

Does anyone know how to decide the default paramter value LIMIT that is
used in MAP_SET so that if I use it that will generate the same result as
the one that I don't use it. For example, how to find 'limit' so that the
following two commands will generate the same results.

MAP_SET, 60, 0, /ORTHO, /GRID, /CONTINENT
and
MAP_SET, 60, 0, /ORTHO, /GRID, /CONTINENT, $
LIMIT=[latmin, lonmin, latmax, lonmax]

Thanks.

Gary

Report message to a moderator

[Message index]

		map_set question By: gfu on Tue, 09 July 1996 00:00
		Re: Map_Set Question By: gennari on Fri, 21 February 1997 00:00
		Re: Map_Set Question By: gennari on Fri, 21 February 1997 00:00
		Re: Map_Set Question By: davidf on Fri, 21 February 1997 00:00
		Re: Map_Set Question By: Andy Loughe on Mon, 24 February 1997 00:00
		Re: Map_Set Question By: Tim Patterson on Mon, 24 February 1997 00:00
		Re: Map_Set Question By: Andy Loughe on Mon, 24 February 1997 00:00
		Re: map_set question By: Theo Brauers on Thu, 16 September 1999 00:00
		Re: map_set question By: Craig Markwardt on Thu, 16 September 1999 00:00
		Re: map_set question By: Harald Frey on Thu, 16 September 1999 00:00

Previous Topic:	Save, /Compress (was Re: reading in binary data)
Next Topic:	Re: need help on ROI subscript

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 17:35:25 PDT 2025

Total time taken to generate the page: 0.00441 seconds