comp.lang.idl-pvwave archive: archive » Re: How to size plots on a postscript device?

Home » Public Forums » archive » Re: How to size plots on a postscript device?

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: How to size plots on a postscript device? [message #6859]

Fri, 23 August 1996 00:00

Christian Soeller
Messages: 46
Registered: August 1996

Member

Hans van Leeuwen <leeuwen@sci.kun.nl> writes:

> Can somebody tell me how to size a combination
> of plots prepared with !p.multi such that on a
> postscript device, the full printing area can be
> used?

You use device commands with the appropriate keywords (xoffset,
yoffset, xsize, ysize). A look at the idl reference manual sections
IDL_Graphics_Devices->The_Postscript_Device->PostScript_Positioning &
following subsection should explain what you need.

Hope this helps,

Christian

------------------------------------------------------------ --------
Christian Soeller mailto: csoelle@sghms.ac.uk
St. Georges Hospital Medical School Dept. of Pharmacology
Cranmer Terrace London SW17 0RE

Report message to a moderator

[Message index]

		Re: How to size plots on a postscript device? By: Christian Soeller on Fri, 23 August 1996 00:00
		Re: How to size plots on a postscript device? By: MICHEL KRUGLANSKI on Thu, 22 August 1996 00:00

Previous Topic:	Lectureship at Warwick
Next Topic:	Re: [Q]Passing parts of structure arrays between routines

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Oct 10 08:15:07 PDT 2025

Total time taken to generate the page: 0.08320 seconds