comp.lang.idl-pvwave archive: archive

Home » Public Forums » archive » PRINTER object

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

PRINTER object [message #10505]

Tue, 09 December 1997 00:00

Matthew Hanson
Messages: 11
Registered: October 1997

Junior Member

Has anyone had problems with size when using the printer object?
When I print using the IDLgrPrinter object i have several problems.
1) The print dialog widgets don't work very well. If compression is
turned on then nothing prints and you are not told why. After choosing
Print you then have to go to the Setup Printer Dialog. After you set
this up then it prints!?
2) When it finally prints, the image (IDLgrScene) is a few inches wide
by about an inch in the lower left hand corner of the page, regardless
of the paper size setting.
Anyone else encounter these problems?
-matt

--
Matthew Hanson

KTAADN, Inc. Phone: (617)527-0054
1320 Centre Street, Suite 201 Fax: (617)527-9321
Newton, MA 02159

matt@ktaadn.com matth@who.net vroomfogle@worldnet.att.net

Report message to a moderator

[Message index]

PRINTER object

By: Matthew Hanson on Tue, 09 December 1997 00:00

Previous Topic:	Level 1B
Next Topic:	Re: IDL Emacs Modes Kidnapped

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Tue Dec 02 11:41:41 PST 2025

Total time taken to generate the page: 0.71966 seconds